Page 32 - ISCAR FACE GROOVING LINES
P. 32
FACE GROOVE-TURN GFQR CDX INSL
Face Grooving Inserts 5
DAXN-DAXX
WF .
CW RE
Recommended
METRIC Machining Data
Dimensions
f face-groove
Designation CW RE CWTOL(1) RETOL(2) CDX DAXN(3) DAXX(4) IC528 (mm/rev)
GFQR 12-1.00-0.05 1.00 0.05 0.02 0.030 1.50 12.0 16.0 • 0.01-0.04
GFQR 12-1.50-0.20 1.50 0.20 0.02 0.030 2.50 12.0 17.0 • 0.01-0.04
2.00 0.20 0.02 0.030 3.00 12.4 18.0 • 0.02-0.05
GFQR 12-2.00-0.20 2.50 0.20 0.02 0.030 3.00 13.0 19.0 • 0.02-0.05
GFQR 12-2.50-0.20
• For detailed cutting data, see pages 162-164
(1) Cutting width tolerance (+/-)
(2) Corner radius tolerance (+/-)
(3) Minimum penetration diameter
(4) Maximum penetration diameter
GFQR CDX INSL DAXN-DAXX
Face Grooving Inserts .197
WF Recommended
CW RE Machining Data
INCH f face-groove
Dimensions (IPR)
Designation CW RE CWTOL(1) RETOL(2) CDX DAXN(3) DAXX(4) IC528• .0004-.0016
• .0004-.0016
GFQR 12-1.00-0.05 .039 .0020 .0008 .0012 .059 .47 .63 • .0008-.0020
GFQR 12-1.50-0.20 .059 .0079 .0008 .0012 .098 .47 .67 • .0008-.0020
.079 .0079 .0008 .0012 .118 .49 .71
GFQR 12-2.00-0.20 .098 .0079 .0008 .0012 .118 .51 .75
GFQR 12-2.50-0.20
• For detailed cutting data, see pages 162-164
(1) Cutting width tolerance (+/-)
(2) Corner radius tolerance (+/-)
(3) Minimum penetration diameter
(4) Maximum penetration diameter
30 ISCAR
