Page 23 - ISCAR FACE GROOVING LINES

OAL FACE GROOVE-TURN

PICCO-015-N DAXN CDX
(Face Grooving) DCONMS
Inserts with Internal Coolant a CW
Channel for Deep Face Grooving

LU

METRIC Recommended
Dimensions Machining Data

Designation DAXN(1) CW LU DCONMS a OAL IC908 f face-groove
8.0 2.50 19.00 7.05 5.90 41.00 (mm/rev)
PICCO R 015.2515-20N 8.0 3.00 19.00 7.05 5.90 41.00
PICCO R 015.3015-20N 8.0 3.00 29.00 7.05 5.90 51.00 • 0.01-0.04
PICCO R 015.3015-30N • 0.02-0.05
INCH • 0.01-0.04

Dimensions Recommended
Machining Data
Designation DAXN(1) CW LU DCONMS a OAL IC908
1.614 f face-groove
PICCO R 015.2515-20N .31 .098 .7480 .278 .232 1.614 (IPR)
PICCO R 015.3015-20N .31 .118 .7480 .278 .232 2.008
.31 .118 1.1417 .278 .232 • .0004-.0016
PICCO R 015.3015-30N • .0008-.0020
• .0004-.0016

• Only right-hand inserts are available as standard, left-hand inserts on request • All inserts are with sharp corners

• Solid tools are suitable for PICCO-N / PICCO ACE-N type holders only • For detailed cutting data, see pages 162-164

(1) Minimum axial grooving diameter

21