Page 9 - parting_4_productivity_3375101
P. 9
JT J
TAG N-J/JS/JT CW RE
Single-Ended Inserts for 7º
Parting, Grooving and
Slitting Soft Materials
Recommended
Dimensions Tough 1 Hard
Machining Data
f groove
Designation CW RE CWTOL (2) RETOL (3) IC830 IC1030 IC5400 IC1010 IC808 IC908 IC20 IC807 (mm/rev)
TAG N2J 2.00 0.20 0.04 0.050 • • • • • • 0.04-0.12
TAG N2JS 2.00 0.02 0.04 0.020 • • 0.03-0.08
TAG N2JT 2.00 0.20 0.04 0.050 • • • • 0.04-0.10
TAG N3J 3.05 0.20 0.04 0.050 • • • • • • • • 0.04-0.16
TAG N3JS 3.05 0.02 0.04 0.020 • • 0.04-0.10
TAG N3JT 3.05 0.20 0.04 0.050 • • • • 0.05-0.18
TAG N3.2JT 3.25 0.20 0.04 0.050 • • 0.05-0.18
TAG N4J 4.00 0.24 0.04 0.050 • • • • • • • 0.04-0.18
TAG N4JT 4.05 0.24 0.04 0.050 • • • • 0.06-0.20
TAG N5J 5.05 0.25 0.04 0.050 • • 0.05-0.20
TAG N5JT 5.05 0.25 0.04 0.050 • • • 0.06-0.22
• JT chipformer has the basic positive configuration of the J-type and a reinforced negative frontal edge; most suitable for soft materials at low to medium feeds.
Cutting width tolerance (+/-)
(2)
Corner radius tolerance (+/-)
(3)
CW
TAG N-LF RE 7°
Single-Ended Inserts for
Parting, Grooving and
Slitting Stainless Steel
Recommended
Dimensions Tough 1 Hard
Machining Data
IC830 IC1030 IC5400 IC1010 IC808 f groove
Designation CW RE CWTOL (1) RETOL (2) (mm/rev)
TAG N2LF 2.00 0.20 0.04 0.030 • • • • • 0.03-0.08
TAG N3LF 3.05 0.20 0.04 0.030 • • • • • 0.04-0.10
(1) Cutting width tolerance (+/-)
(2) Corner radius tolerance (+/-)
9